Qlogic 200 Series Manuel d'utilisateur télécharger pdf (Page 3)

Quick Start Guide

Installation Instructions

This quick start guide describes how to install and configure your new QLogic Host Bus Adapter in three simple steps:

■ Step 1. Install the Adapter Hardware

■ Step 2. Install the Adapter Driver

■ Step 3. Install QConvergeConsole

Step 1. Install the Adapter Hardware

To install the adapter hardware, you need to open the computer and locate the appropriate bus slot. If necessary, consult

your computer system manual for instructions to remove the computer cover.

To install the adapter hardware:

1. Power off the computer and all attached devices such as monitors, printers, and external components.

2. Disconnect the power cable.

3. Remove the computer cover and find an appropriate empty bus slot.

4. Pull out the slot cover (if any) by removing the screw or releasing the lever.

5. Install the low-profile bracket (if required).

6. Grasp the adapter by the top edge and seat it firmly into the appropriate slot (see Figure 1).

7. Refasten the adapter’s retaining bracket using the existing screw or lever.

8. Close the computer cover.

9. Plug the Fibre Channel cable into the adapter.

10. Plug in the power cable and turn on the computer.

CAUTION

Keep the adapter in the antistatic bag until installation. The Host Bus Adapter contains parts that can be damaged by

electrostatic discharge (ESD). Before handling the Host Bus Adapter, use standard methods to discharge static

electricity. Place the Host Bus Adapter on the bag when examining it. Retain the bag for future use.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Qlogic 200 Series Manuel d'utilisateur Page 3