Qlogic SANbox2-8c Manuel d'installation télécharger pdf (Page 13)

Configuring Fibre Channel on your PDR Series

16 April, 2003 Fibre Channel Switch 13

To configure your Profile system for use in a Fibre Channel environment, follow the

instructions in the Profile User Manual. In addition to these instructions, you must

also set Fibre Channel Switch Mode ON. You can do this in one of two ways:

• Type the following command from the Command Prompt: fcconfig -s on.

• In Configuration Manager, select Switch Compatibility Mode in the Fibre Channel

Configuration dialog box.

NOTE: You do not need to set the Fibre Channel hardware address of Profile

systems connected to the Fibre Channel switch. These addresses are assigned

dynamically in a fabric environment.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Pas de commentaire

Qlogic SANbox2-8c Manuel d'installation Page 13