Qlogic QLA22xx board Guide d'installation télécharger pdf (Page 37)

FC0153302-00 F 7-1

Section 7

Solaris x86 Driver Installation

(QLA2200)

7.1

Introduction

This section provides instructions for installing the Solaris x86 driver under the

following operating system conditions:

■ Installation of the Solaris x86 operating system on a Fibre Channel disk that

is attached to the QLA22xx board. (The QLA22xx board is installed as a

boot adapter.)

■ Installation of the QLA22xx board as an add-on adapter in an already

installed Solaris x86 (v2.6 or 7) operating system.

7.2

Solaris x86 Driver Files

The latest version of the Solaris x86 driver package is available on the QLogic web

site. The files in the driver package cannot be read nor installed from a DOS

environment. Be sure to review the README.TXT for both new and changed

information.

7.3

Solaris x86 Installation

To install the Solaris x86 driver on the Fibre Channel hard disk that is attached to

the QLA22xx board (installed as a boot adapter), perform the installation procedures

in section 7.3.1. To install the Solaris x86 driver on a system that uses the QLA22xx

as an add-on adapter, perform the installation procedures in section 7.3.2.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 61 62

Pas de commentaire

Qlogic QLA22xx board Guide d'installation Page 37