Qlogic SANsurfer FC HBA Manager Guide de l'utilisateur télécharger pdf (Page 108)

7 – Setting Up Connections

Binding Target Devices Using the Target Persistent Binding Tabbed Page

7-40 FS0054603-00 C

In Windows 2000/Windows Server 2003, target IDs can be assigned only to

ports that will be configured. Valid targets ID values are in the range 0–(n–1),

where n is the number of targets attached to the HBA.

In Solaris SPARC, the target ID cannot be modified if the device has been

selected as a boot device.

Once persistent binding information for the targets is saved, the ports retain the

assigned target IDs across reboots.

4. Complete binding the target IDs by clicking one of the buttons at the bottom of

the Fibre Channel Port Configuration dialog box:

❑ Save.

❑ The Security Check dialog box displays. In the Enter Password box,

type the password. Click OK.

❑ The current configuration is saved. Any previously saved configuration

for the current HBA is overwritten.

❑ Cancel. The current configuration is not saved.

7.8

Binding Target Devices Using the Target Persistent Binding Tabbed

Page

NOTE:

■ This feature is not supported in Novell NetWare.

■ You can also use the General Configuration Wizard (Target Persistent

Binding dialog box) (see section 7.2) or the Fibre Channel Port

Configuration dialog box (see section 7.7) to bind devices attached to

HBA ports. For information about deleting persistent configuration data,

see section 7.9.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 217 218

Pas de commentaire

Qlogic SANsurfer FC HBA Manager Guide de l'utilisateur Page 108