Qlogic MPX200 Guide de l'utilisateur télécharger pdf (Page 161)

Table 22 Configuring multipathing on Citrix XenServer (continued)

Removing second direct path from

controller port (for example, Port

1. From the FC switch, zone out the second direct path.

2. In the left pane, click Hardware HBA virtual disk storage.

3. In the right pane, select the Storage tab.

4. On the Storage page, select the LUN, and then click Rescan.

5. Select the General tab, and then on the General page, check the multiple paths.

Adding router path for the

removed controller port (for

example, Port B)

1. Add the second router path by zoning the presented target and host ports.

2. To check the newly added path, rescan the LUN as in 4.

These validations use the method described in “Zoning in presented targets: Method 1” on page 5-13. Alternatively,

you can use the method described in “Zoning in presented targets: Method 2”.

Citrix XenServer multipath configuration 161

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 179 180

Pas de commentaire

Qlogic MPX200 Guide de l'utilisateur Page 161