Qlogic SANsurfer iSCSI HBA Manager Guide de l'utilisateur télécharger pdf (Page 109)

5 – Non-Interactive Mode Commands

Non-interactive Commands

SN0054621-00 E 5-25

-ping

(Ping Target)

To ping the target device specified IP address, enter the -ping command as

follows:

-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size>

The following provides the IPv6 source address values:

Where:

For information on the interactive version of this command, see “Ping Target (CLI

Option -ping)” on page 4-30.

-ps

To view persistent targets for the HBA port, enter the -ps command as follows:

-ps <hba_port_inst> [Target ID]

If you do not specify the [Target ID], SANsurfer iSCSI HBA CLI displays all

targets for the specified HBA port number. If you do not specify the port instance

[hba_port_inst]

nor the Target ID, [Target ID], SANsurfer iSCSI HBA CLI

displays all target IDs for all HBA ports in the system.

There is no interactive command for this function.

-pu

To unbind a persistent target, enter the -pu command as follows:

-pu <hba_port_inst> <Target ID>

0 = Do Not Care

1 = Local Link

2 = Address 0

3 = Address 1

hba_port_inst = The HBA port that sends the ping.

IP Address = The IP address to pin.

Ping Count = The number of ping packets you want (1–[2^31]).

Packet Size = The size of the ping packet 0-64kB

IPv6 Source

Address

= Origin device

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 183 184

Pas de commentaire

Qlogic SANsurfer iSCSI HBA Manager Guide de l'utilisateur Page 109