Qlogic QLogic 12000 Series Guide d'installation Page 77

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 134
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 76
1–Installation
Component LEDs
D000140-001 D 1-67
12200 and 12300
Figure 1-59. 12200 and 12300LEDs
IB Port LEDs
Each module IB port has a Green IB link status LED that provide the following
indications:
On - the logical link is up (port is in the Active state).
Off - the physical link is down (port is in the Down state).
Status
The status LED indicates one of the following conditions:
Steady Green - the module is operating normally.
Blinking Green - LED test state.
Off - module is in the removable state.
Attention
The Attention LED indicates one of the following conditions:
Off - the system functioning normally.
Steady Amber - the system requires some attention, which could indicate
one of the following conditions:
The switch temperature is at a warning level on the module.
The switch silicon temperature is at a warning level (approximately 90
degrees C).
Vue de la page 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 133 134

Commentaires sur ces manuels

Pas de commentaire