Qlogic QLogic 12000 Series Guide d'installation Page 57

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 114
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 56
1–Installation
Component LEDs
D000102-000 B 1-47
12200 and 12300
Figure 1-41 12200 and 12300LEDs
IB Port LEDs
Each module IB port has a Green IB link status LED that provide the following
indications:
On - the logical link is up (port is in the Active state).
Off - the physical link is down (port is in the Down state).
Status
The status LED indicates one of the following conditions:
Steady Green - the module is operating normally.
Blinking Green - LED test state.
Off - module is in the removable state.
Attention
The Attention LED indicates one of the following conditions:
Off - the system functioning normally.
Steady Amber - the system requires some attention, which could indicate one
of the following conditions:
The switch temperature is at a warning level on the module.
The switch silicon temperature is at a warning level (approximately 90 degrees
C).
Vue de la page 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 113 114

Commentaires sur ces manuels

Pas de commentaire