Qlogic SANbox-16STD Installer's/ Guide d'installation télécharger pdf (Page 15)

CHAPTER

Switch Activation

This chapter contains the procedures for bringing the new Sun StorEdge SAN 4.0

Release software onto the network. For more details about the switch, refer to the

documentation delivered with your switch.

Overall Installation Order

Use this manual, the Sun StorEdge SAN 4.0 Release Configuration Guide, and the

documentation that came with your switch.

1. Install the Solaris patch cluster on the host.

2. Install the SAN 4.0 packages and patches (including HBA drivers).

3. Install the HBAs, connect the hosts, switches and storage devices

4. Assign IP address to the switch ethernet ports.

5. Start the GUI for your switch.

6. Verify and load the switch firmware.

7. Verify and set the domain ID

8. Configure the switch ports.

9. Configure and activate zonesets and zones.

10. Configure the fabric devices

11. Enable multipathing (optional)

12. Mount the filesystems.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Pas de commentaire

Qlogic SANbox-16STD Installer's/ Guide d'installation Page 15