Qlogic iSR6142 Manuel d'utilisateur

SN0051408-00 C 1Applications NoteConfiguring the iSR6142 for FCIP1IntroductionThis applications note provides step-by-step instructions for connectin

SN0051408-00 C 10Figure 4-1. Single E_PortFigure 4-2 shows how a Fibre Channel switch with more than one online E_Port must determine from which E_Po

SN0051408-00 C 11Figure 4-4. Multiple E_Ports, Single SwitchesFigure 4-5 shows dual E_Ports connecting HA SANs. This configuration provides both Fibr

SN0051408-00 C 12© 2007, 2009 QLogic Corporation. Specifications are subject to change without notice. All rights reserved worldwide. QLogic and the

SN0051408-00 C 23Configuration Steps1. Gather the following information required to configure the iSR6142 routers (review the topology diagrams in th

SN0051408-00 C 34. Configure FCIP routes from the QRouter command line interface (CLI) using a Telnet session or serial connection (see Figure 3-1) w

SN0051408-00 C 4Figure 3-2. Configuring FCIP Routers from iSCSI/FC Router Manager5. Configure the link rate on the Ethernet switches and routers. The

SN0051408-00 C 56. Configure the iSR6142 Ethernet performance:a. The TCP window size defines the maximum amount of data transmitted that was unacknow

SN0051408-00 C 67. Verify the IP connection between the local and remote routers using the router’s ping feature through the QRouter CLI (see Figure

SN0051408-00 C 78. Connect the iSR6142 routers to the Fibre Channel switches: a. If the Fibre Channel switch is from Brocade, then the switch port co

SN0051408-00 C 8Figure 3-5. Setting the Brocade Switch Port ISL Mode to Enableb. Connect the local router to the local Fibre Channel switch.c. Connec

SN0051408-00 C 9d. Verify the router-to-switch Fibre Channel connectivity: On the Fibre Channel switches, the port connected to the router should ap