Qlogic SANblade 2300 Series Guide de l'utilisateur télécharger pdf (Page 60)

4 – QLA2342/2342L

FCode

4-8 FC2354601-00 J

3. If the connection mode is not correct based on the devices connected to the

QLA2342/2342L HBA, change it using the set-connection-mode command.

For example:

ok 0 set-connection-mode

The new connection mode displays. For example:

Calculating NVRAM checksum, please wait...

Current HBA connection mode: 0 - Loop Only

Possible connection mode choices:

0 - Loop Only

1 - Point-to-point only

2 - Loop preferred, otherwise point-to-point

4.3.3

Setting the QLA2342/2342L HBA Loop ID

When the QLA2342/2342L HBA is currently operating in loop mode (through

connection mode 0 or connection mode 2), perform the following steps to view its

loop ID and change it if necessary:

1. Select the QLA2342/2342L HBA attached to the Fibre Channel device from

which you want to boot. For example, type the following at the ok prompt:

ok " /pci@1f,0/pci@1/QLGC,qla@4" select-dev

2. To view the loop ID, type the show-adapter-loopid command.

ok show-adapter-loopid

The loop ID displays. For example:

Adapter loopid - 7c

3. If the loop ID is not correct, change it using the set-adapter-loopid command.

For example:

ok 0 set-adapter-loopid

The new loop ID displays. For example:

Adapter loopid - 0

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 167 168

Pas de commentaire

Qlogic SANblade 2300 Series Guide de l'utilisateur Page 60