Qlogic QConvergeConsole CLI 8200 Series Guide de l'utilisateur télécharger pdf (Page 113)

6–iSCSI Noninteractive Commands

-c (Display Configured Port Settings)

SN0054667-00 B 6-5

-c

(Display Configured Port Settings)

To view the configured settings for the port, issue the -c command as follows:

-c [hba_port_inst]

When you specify a port instance, information for only that adapter is shown.

When you do not specify a port instance, information for all adapter ports in the

system is shown.

-ch

(HBA Information)

To display the adapter’s configured settings, issue the -ch command as follows:

-ch [hba_port_inst]

When you specify a port instance, information for only that adapter is shown.

When you do not specify a port instance, information for all adapter ports in the

system is shown.

-chapmap

(Display Targets Using CHAP Entries)

To display the map of targets to CHAP table entries, issue the -chapmap

command as follows:

-chapmap <hba_port_inst>

-cpbootcode

(Clear Primary Boot Target Information)

To clear the primary boot target and LUN, issue the -cpbootcode command as

follows:

-cpbootcode <hba_port_inst>

-csbootcode

(Clear Secondary Boot Target Information)

To clear the secondary boot target and LUN, issue the -csbootcode command

as follows:

-csbootcode <hba_port_inst>

NOTE:

This command is not active for the PPC.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 299 300

Pas de commentaire

Qlogic QConvergeConsole CLI 8200 Series Guide de l'utilisateur Page 113