Qlogic QConvergeConsole CLI 8200 Series Guide de l'utilisateur télécharger pdf (Page 128)

6–iSCSI Noninteractive Commands

-nh (Configure iSCSI Settings)

6-20 SN0054667-00 B

To set only the local link address, issue the following command:

-netconf6 0 -IPLL fe80::1

To set everything automatically, issue the following commmand:

-netconf6 0 -IPLLA -IPR01A -IPRRA

To disable the IPv4 network, issue the following command:

-netconf6 0 -DISN4

To disable the IPv4 and IPv6 networks, issue the following command:

-netconf6 0 -DISN4 DISN6

-nh

(Configure iSCSI Settings)

To set the adapter-level parameters for multiport adapters, issue the -nh

command as follows:

-nh <hba_port_inst> <Config name | Config alias> <Value>

[<<Config name | Config alias>> <Value> …]

The valid parameters and their values are shown in Table 6-3.

-pa

(Add a Target)

To add persistent targets, issue the -pa command as follows:

-pa <hba_port_inst> <IP Address> [-PORT port number] [-INAME iSCSI

Name]

If you do not specify a port number [-PORT port number], QConvergeConsole

CLI uses the default number 3260. If you do not specify an iSCSI name [-INAME

iSCSI Name], QConvergeConsole CLI uses the default value, an empty string.

-pad

To view all targets for a port, issue the -pad command as follows:

-pad <hba_port_inst>

-pb

(Bind Target)

To bind a target (make it persistent), issue the -pb command as follows:

-pb <hba_port_inst> <Target ID>

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 299 300

Pas de commentaire

Qlogic QConvergeConsole CLI 8200 Series Guide de l'utilisateur Page 128