Qlogic Fibre Channel HBA and VM Spécifications télécharger pdf (Page 16)

4 – Configuring the Host and VMM Servers

Adding Hosts to the VMM Server

4-2 FC0054605-00 A

5. Install the QLogic SANsurfer FC HBA Manager agent (qlremote) or

SANsurfer FC HBA CLI.

6. Install the storage vendor’s MPIO solution software (for example, EMC

PowerPath).

7. Install Microsoft Virtual Disk service.

8. Configure the QLogic Fibre Channel switch so that the physical FC adapters

on both host servers have access to the same storage array. The switch is

configured by creating the appropriate zones.

For example, if you have storage array A and two hosts (Server A and

Server B,) you can create Zone1, which has Server A and array A, and

Zone2, which has Server B and array A. This configuration ensures that both

host Server A and host Server B can see any LUNs presented to them via

storage array A.

Adding Hosts to the VMM Server

Add all hosts to be managed by the VMM server by clicking the Add hosts button

on the VMM2008 Actions toolbar.

Once complete, the VMM Administration console will be similar to Figure 4-1.

Figure 4-1. Adding Hosts to the VMM Server

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Pas de commentaire

Qlogic Fibre Channel HBA and VM Spécifications Page 16