Qlogic QLogic Fibre Channel Switch Guide d'installation télécharger pdf (Page 135)

B – Command Line Interface

Set Config Command

59055-00 B B-39

zoning

Initiates an editing session in which to change switch zoning attributes. The

system displays each parameter one line at a time and prompts you for a value.

For each parameter, enter a new value or press the Enter key to accept the

current value shown in brackets.

Table B-12. Set Config Zoning Parameters

Parameter Description

FC-SW-2

AutoSave

Available only when the FC-SW-2 Compliant parameter is

True, this parameter enables (True) or disables (False) the

saving of changes to active zone set in the switch’s permanent

memory. Refer to ”FC-SW-2 Compliant” on page B-37. The

default is True.

Disabling the Autosave parameter can be useful to prevent the

propagation of zoning information when experimenting with

different zoning schemes. However, leaving the Autosave

parameter disabled can disrupt device configurations should a

switch have to be reset. For this reason, the Autosave

parameter should be enabled in a production environment.

Default Visibility Enables (All) or disables (None) communication among the

switch’s ports/devices and the fabric in the absence of an

active zone set. The default is All.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 205 206

Pas de commentaire

Qlogic QLogic Fibre Channel Switch Guide d'installation Page 135