Qlogic 3000 SERIES Spécifications Page 21

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 114
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 20
3–Installation Instructions
Linux Driver Installation
NE0154601-00 A 3-5
4. Type the following command to install the tools RPM:
rpm -ivh nx_tools-[version].rpm
5. Type the following command to load the driver:
modprobe -v nx_nic
SUSE
®
To install the driver on a SUSE system:
1. Type the following command to install the RPM source:
rpm -iv nx_nic-[version].src.rpm
2. Type the following command to build the binary RPM:
rpmbuild -bb /usr/src/packages/SPECS/nx_nic-[version].spec
3. Type the following command to install the binary RPM:
rpm -ivh /usr/src/packages/RPMS/[arch]2/nx_nic-[version].[arch].rpm
The [arch] variable designates the system architecture. Some [arch]
variables are i386, i586, i686, x86_64, depending on the system.
4. Type the following command to install the tools RPM:
rpm -ivh nx_tools-[version].rpm
5. Type the following command to load the driver:
modprobe firmware_class
modprobe -v nx_nic
QLogic Adapter Configuration
To configure the QLogic adapter:
1. Type the following command to identify the Ethernet interface:
cat /proc/net/nx_nic/dev0/stats
2. Type the following command to assign an IP address:
ifconfig eth[n] [ip address]
Vue de la page 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 113 114

Commentaires sur ces manuels

Pas de commentaire