Qlogic Fibre Channel NPIV Storage Networking Guide Spécifications télécharger pdf (Page 34)

4-VMM2008 R2 Setup, VM Creation, and NPIV SAN Migration

VM Creation

4-2

Figure 4-1. Hosts Added to VMM2008 R2

In Figure 4-1, the hosts win-3f1kc24knkr.hypernpiv.com and

HostServerA.hypernpiv.com have been added.

VM Creation

This section describes the additional steps needed to create a VM on a Fibre

Channel SAN LUN presented to a virtual adapter port.

Before you can use VMM2008 R2 to transfer virtual machines on a SAN,

automount must be disabled on the Hyper-V hosts that will be either a source or

destination computer for SAN transfers. To disable automount:

1. Open a new command prompt.

2. Type diskpart.

3. At the prompt, type automount disable.

The following message appears:

Automatic mounting of new volumes disabled.

4. Type exit.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Pas de commentaire

Qlogic Fibre Channel NPIV Storage Networking Guide Spécifications Page 34