Qlogic iSR6142 Guide d'installation télécharger pdf (Page 67)

SN0051102-00 A 6-1

6 Removal/Replacement

This section describes the removal and replacement procedures for the following

field replaceable units (FRU):

 SFP transceivers

 The router (see page 6-2)

SFP Transceiver Removal and Replacement

You can remove and replace the SFP transceivers while the router is operating

without damaging the router or the transceiver. However, doing so will interrupt

transmission on the affected port until the transceiver is installed.

 To remove a transceiver, gently press the transceiver into the port to release

the tension, then pull the release tab or lever and remove the transceiver.

Different transceiver manufactures have different release mechanisms.

Consult the documentation for your transceiver.

 To install a transceiver, insert the transceiver into the port and gently press

until it snaps in place.

NOTE:

The SFP transceiver will fit only one way. If the SFP does not install under

gentle pressure, flip it over and try again.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 119 120

Pas de commentaire

Qlogic iSR6142 Guide d'installation Page 67