Qlogic QLA2342 Guide de l'utilisateur télécharger pdf (Page 24)

EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment

Installing and Configuring the HBA and Driver

hba0-link-down-error — Disables all link_down time out values. The

sd driver will not be notified of any error conditions if the QLogic

driver detects a link_down condition. If the EMC storage array goes

off line or the link with the host is broken for any reason, the QLogic

driver holds all pending I/Os indefinitely until the link is restored or

the storage array rejoins the loop. In a PowerPath

or VERITAS DMP

environment, this variable should be enabled (1) so the PowerPath or

VERITAS DMP driver will be notified of any error conditions.

hba0-link-down-timeout — Time the driver waits for a Fibre

Channel loop to come up before reporting the failure.

hba0-persistent-binding-configuration:

0 = Report to OS discovery of both bound and non-bound devices

1 = Report to OS discovery of bound devices only

hba0-persistent-binding-by port ID — Persistent binding by port ID.

hba0-fast-error-reporting — Fast error reporting to Solaris.

hba0-extended-logging — Disable/Enable logging of driver detected

events occurring either in the driver or Fibre Channel bus.

hba0-queue-full-retry-count — Number of times to retry a SCSI

queue full error.

hba0-queue-full-retry-delay — Time to wait after a SCSI

queue full

error before starting any new I/O commands.

hba0-security-protocols — Disable/Enable Fibre Channel security

protocol DH-CHAP.

hba0-FDMI-support — Disable/Enable the Fabric-Device

Management Interface support.

hba0-VDP-support — Target/LUN VDP data for failover

configuration support.

What next? Proceed to “Editing /kernel/drv/sd.conf” on page 25.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

Pas de commentaire

Qlogic QLA2342 Guide de l'utilisateur Page 24