Qlogic QLA2342 Guide de l'utilisateur télécharger pdf (Page 48)

EMC Fibre Channel with QLogic Host Bus Adapters in the Solaris Environment

Configuring a Boot Device on the EMC Storage Array

Example — After modification:

Note: To increase system performance, you can leave the swap partition

on the internal boot drive by leaving the fourth line

(/dev/dsk/c3t0d0s1 - - swap - no -) unchanged.

4. At the %> prompt, type umount /mnt and press ENTER to

unmount the root partition.

5. Repeat steps 1, 2, and 4 for the /usr partition. In the current root

directory:

a. At the %> prompt, type mount /dev/dsk/c3t0d0s6 /mnt and

press ENTER.

At the %> prompt, type the following and press ENTER:

ufsdump 0f - /dev/dsk/c0t0d0s6 | ( cd /mnt; ufsrestore rf -)

b. At the %> prompt, type umount /mnt and press ENTER.

6. Repeat steps 1, 2, and 4 for any other partitions to be mounted

from the Symmetrix boot device.

Modifying OpenBoot

Follow this procedure to modify OpenBoot:

1. Halt the system and issue a reset to get to the OpenBoot

environment:

a. At the %> prompt, type halt and press ENTER.

b. At the OK> prompt, type setenv auto-boot? false and press

ENTER, so the system will display the OK> prompt after

reset.

c. At the OK> prompt, type reset-all and press ENTER

2. For the intended (target) Fibre Channel boot HBA, set the

topology for arbitrated loop:

#device device mount FS fsck mount mount

#to mount to fsck point type pass at boot options

/dev/dsk/c3t0d0s1 - - swap - no -

/dev/dsk/c3t0d0s0 /dev/rdsk/c3t0d0s0 / ufs 1 no -

/dev/dsk/c3t0d0s6 /dev/rdsk/c3t0d0s6 /usr ufs 1 no -

swap - /tmp tmpfs - yes -

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 61 62

Pas de commentaire

Qlogic QLA2342 Guide de l'utilisateur Page 48