Qlogic QLA4010 Guide d'installation télécharger pdf (Page 39)

Booting from the External Storage Array

1-25

Installation and Configuration

The directory listing should contain the QLogic EFI boot code/utility

which was downloaded to the media (as shown in Figure 1-21 on

page 1-24).

The files of importance will take the following form:

Type efiutil and press Enter.

Figure 1-22 Fibre Channel Card Efi Utility

The QLogic HBA(s) installed in the server will be listed (as shown in

Figure 1-22). Note the "firmware" version listed in the utility. If the

firmware is listed as a specific version (not a series of zeroes), and

"AUX" is not listed next to the firmware field at the top of the report

then the EFI driver and firmware have been loaded on the HBA(s);

proceed to the section immediately following Figure 1-26 on

page 1-30.

efiutil.efi

QLogic EFI utility for updating adapter

driver/firmware

efiaux.drv

EFI auxiliary driver (used by efiutil when EFI

drivers are not loaded)

qlNNNNef.bin

EFI driver image file; written to adapter flash

(where xxxx refers to the chipset used on the

HBA - in this example, “2312” refers to the

chipset present on QLA2340/QLA2342 HBAs)

qlNNNNfw.bin

Adapter firmware file, written to adapter flash

(where xxxx refers to the chipset used on the

HBA - in this example, “2312” refers to the

chipset present on QLA2340/QLA2342 HBAs)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 117 118

Pas de commentaire

Qlogic QLA4010 Guide d'installation Page 39