Qlogic QConvergeConsole CLI 2400 Series Guide de l'utilisateur télécharger pdf (Page 102)

5–Fibre Channel Noninteractive Commands

-tb (Target Beacon On/Off)

5-34 SN0054667-00 C

To show specific target information for a specific target on an adapter, issue the

following command:

# qaucli -pr fc -t (<hba instance> | <hba wwpn>) (<target wwpn> |

<target port id>)

Where:

To show the target information on all adapters, issue the following command:

-t [<all>]

To show the target information on a specific adapter, issue the following

command:

-t (<hba instance> | <hba wwpn>)

To show the target information for a specific target on a specific adapter, issue the

following command:

-t (<hba instance> | <hba wwpn>) (<target wwpn> | <target port id>)

iiDMA (intelligent interleaved direct memory access) settings include:

 —targets | –t applies to all targets.

 <speed> indicates the supported intelligent interleave factor: 1, 2, 4, or

8Gbps.

-tb

(Target Beacon On/Off)

To start or stop flashing a target’s LED, issue the following command:

# qaucli -pr fc -tb (<hba instance> | <hba wwpn>) (<target wwpn>)

(<0 | ON> | <1 | PRESET>)

hba instance = Adapter number (use -g command to find)

hba wwpn = World wide port name of the adapter

target wwpn = World wide port name of the target

target port id = Port ID of the target

NOTE:

 The <0 | ON> option flashes the LED until interrupted.

The <1 | PRESET> option flashes the LED 12 times.

 This feature is supported only on JBOD (“just a bunch of disks”) devices.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 365 366

Pas de commentaire

Qlogic QConvergeConsole CLI 2400 Series Guide de l'utilisateur Page 102