Qlogic QConvergeConsole CLI 2400 Series Guide de l'utilisateur télécharger pdf (Page 110)

6–iSCSI Noninteractive Commands

-bootcodemode (Set BIOS/UEFI [or FCode] Mode)

6-4 SN0054667-00 C

The -bootcode command updates the boot code image, which should be done

when QLogic releases a new boot code with bug fixes or enhancements. At the

prompt, type the name of the file containing the boot code image to upload to the

adapter.

To update the boot code image, issue the -bootcode command as follows:

-bootcode <hba_port_inst> <Bootcode Code Image File Name>

-bootcodemode

(Set BIOS/UEFI [or FCode] Mode)

To set the boot code mode for QLA4050, QLA4050C, QLE4060C, QLE4062, and

QMC4052 adapters, issue the -bootcodemode command as follows:

-bootcodemode <hba_port_inst> <1>|<2>|<3>

Where:

If adapter DHCP is enabled (see “-ipdhcp (Configure IP Settings)” on page 6-13),

modes 1–3 are allowed. If adapter DHCP is not enabled, boot code DHCP is not

allowed. This mode is not supported for QLA4010 adapters. This mode is not

active for the PPC.

For IBM cards, the following modes are available:

-c

(Display Configured Port Settings)

To view the configured settings for the port, issue the -c command as follows:

-c [hba_port_inst]

When you specify a port instance, information for only that adapter is shown.

When you do not specify a port instance, information for all adapter ports in the

system is shown.

1 = Disabled

2 = Manual mode

3 = DHCP–Root path

4 = DHCP vendor ID

5 = DHCP-auto

6 = Auto

7 = System mode

NOTE:

Boot code DHCP is not allowed for QLA4010 adapters.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 365 366

Pas de commentaire

Qlogic QConvergeConsole CLI 2400 Series Guide de l'utilisateur Page 110