Qlogic QLA22xx board Guide d'installation télécharger pdf (Page 11)

2 – UnixWare 7 Driver Installation Installing the qlc2200 Driver

FC0153302-00 D 2-3

2.4

Installing the qlc2200 Driver

Perform the following steps to install the qlc2200 driver in a previously installed

UnixWare 7.0 or 7.1 system.

1. Make sure you have root privileges.

2. Enter the following text at the prompt to run the pkgadd program:

pkgadd -d diskette1

3. The following prompt appears:

Insert diskette into Floppy Drive 1.

Type [go] when ready,

or [q] to quit: (default: go)

4. Insert the diskette that contains the QLogic driver into drive 1 and press

<ENTER> to select [go].

5. You are prompted to select a driver package. For example:

Installation in progress. Do not remove the

diskette.

The following packages are available:

1 qlc2200 QLogic QLA22XX Series

IHV HBA (i386) 3.01

Select packages(s) you wish to process (or ’all’

to process all packages). (default: all)

[?,??,quit]:

6. Type 1 and press <ENTER> to install the qlc2200 driver.

7. When the driver is installed, the following prompt appears:

Installation of QLogic QLA22XX Series

IHV HBA (qlc2200) was successful.

Insert diskette into Floppy Drive 1.

Type [go] when ready,

or [q] to quit: (default: go)

8. Type q and press <ENTER> to exit the installation program.

9. Remove the diskette that contains the QLogic driver.

10. Reboot the system to load the driver.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Pas de commentaire

Qlogic QLA22xx board Guide d'installation Page 11