Qlogic QLA22xx board Guide d'installation télécharger pdf (Page 19)

4 – Windows NT Driver Installation QL2200IP NDIS Network Driver Installation

FC0153302-00 D 4-5

6. Type the path to the QL2200IP NDIS network driver. For example:

A:\NT\IP

7. Click OK.

8. Select the QLogic QL2200IP Network Driver, then click OK. The

QL2200IP Configuration Utility dialog box opens.

9. Check that the MTU Size is set to the same value that is used on the other

adapters on the network, then click OK.

10. Click Close. The TCP/IP Properties dialog box is displayed.

11. Specify an IP address and subnet mask for each adapter on the network.

Each IP address must be unique and all adapters must use the same subnet

mask. For example:

Adapter 1

IP address: 10.0.0.1

Subnet mask: 255.255.0.0

Adapter 2

IP address: 10.0.0.2

Subnet mask: 255.255.0.0

12. Click OK.

13. Remove the diskette and click Yes to restart the system.

4.5.2

Updating the QL2200IP NDIS Network Driver

Perform the following steps if a QL2200IP NDIS network driver is already installed

and you want to install an updated version of the driver.

1. Open a DOS command prompt window.

2. Change the current directory to the Windows NT driver directory. For

example:

CD \WINNT\SYSTEM32\DRIVERS

3. Make a backup copy of the old driver. You can copy the file into the same

directory with a .SAV extension indicating that it is the saved file. For

example:

COPY QL2200IP.SYS QL2200IP.SAV

4. Insert the diskette that contains the updated QLogic driver into an

appropriate drive.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Pas de commentaire

Qlogic QLA22xx board Guide d'installation Page 19