Qlogic Storage Networking (Unified Fabric Pilot) Guide d'installation télécharger pdf (Page 38)

5–Validation Methods for DCB and FCoE

Validation Step 2—FIP Validation

5-8 51031-00 A

Validation Results

Figure 5-6 shows the FIP test results between the QLogic QLE8152 adapter and

the Cisco Nexus 5000 FCoE switch.

Figure 5-6. FIP Verification Results—Converged Network Adapter

and FCoE Switch

From the captured trace, you can verify the following:

 FIP version used by both devices is 1.

 FCoE VLAN ID returned by the switch is 1002.

 The link is capable of delivering 2181-byte frames.

 The end device was able to log in to the switch with the FIP FLOGI.

 The switch sent an Accept FLOGI that specifies 01181C as the Fibre

Channel Source ID and 0E:FC:00:01:18:1C as the MAC address.

 All subsequent FCoE messages use the source MAC address

0E:FC:00:01:18:1C for the end device.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

Pas de commentaire

Qlogic Storage Networking (Unified Fabric Pilot) Guide d'installation Page 38