Qlogic Storage Networking (Unified Fabric Pilot) Guide d'installation télécharger pdf (Page 42)

5–Validation Methods for DCB and FCoE

Validation Step 3—FCoE Function and I/O Tests

5-12 51031-00 A

Validation Step 3—FCoE Function and I/O Tests

Figure 5-12 shows the three test configurations that validate FCoE function and

I/O in the FCoE fabric:

 Converged Network Adapter host > FCoE switch > FCoE storage

 Converged Network Adapter host > FCoE switch > direct-attached Fibre

Channel storage

 Converged Network Adapter host > FCoE switch > Fibre Channel switch >

Fibre Channel storage

Figure 5-12. I/O Test with Fibre Channel SAN Storage Setup

Validation Process

The following validation steps are used for all three test configurations:

1. Install the Medusa test tools (MLTT) on the Converged Network Adapter

host.

2. Map the target device from the MLTT client interface.

Converged Network Adapter Host > FCoE Switch > FCoE Storage

Converged Network Adapter Host > FCoE Switch > Direct Attached Fibre Channel Storage

Converged Network Adapter Host > Fibre Channel Switch > Fibre Channel Storage

4Gbps

10Gbps

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

Pas de commentaire

Qlogic Storage Networking (Unified Fabric Pilot) Guide d'installation Page 42