Qlogic SANsurfer iSCSI HBA CLI Guide de l'utilisateur télécharger pdf (Page 60)

5 – Non-interactive Mode Commands

-n (Configure iSCSI Settings)

5-4 SN0054621-00 B

5.9

-n

(Configure iSCSI Settings)

Type the following command to set to HBA iSCSI parameters:

-n <HBA No.> <Config Name|Config Alias> <Value>

[<Config Name|Config Alias> <Value> …]

The HBA will be reset after this command is issued.

The

<Config Name|Config Alias> <Value> parameter set can be repeated.

These parameters are defined in table 5-2.

Table 5-2. HBA Parameters

Configuration Name Configuration Alias Value

Add Firmware Options

AFW_Device_Timeouts AFWDT on or off

AFW_AutoConnect AFWAC on or off

ExeThrottle ET 0–32768

FirstBurstLen FB 0–32768

IPOptions

IP_ARP_Redirect IPARP on or off

IP_Address IPAD IP address format

IP_Subnet_Mask IPSM IP address format

IP_Gateway IPGW IP address format

Primary_DNS PDNS IP address format

SLP_Address SLPA IP address format

iSCSIOptions

iSCSI_Header_Digests IHD on or off

iSCSI_Data_Digests IDD on or off

iSCSI_Immediate_Data IID on or off

iSCSI_Initial_R2T IIR2T on or off

iSCSI_Snack ISNACK on or off

iSCSI_Discovery_Logout ID on or off

iSCSI_Strict_iSCSI_Login IS on or off

TCPOptions

TCP_SLP_Use_DA SLPDA on or off

TCP_Auto_Discovery SLPADIS on or off

TCP_SLP_UA SLPUA on or off

TCP_SLP_SA SLPSA on or off

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 79 80

Pas de commentaire

Qlogic SANsurfer iSCSI HBA CLI Guide de l'utilisateur Page 60