Qlogic SANsurfer iSCSI HBA CLI Guide de l'utilisateur télécharger pdf (Page 66)

5 – Non-interactive Mode Commands

-delchap (Delete a CHAP Entry)

5-10 SN0054621-00 B

The HBA will be reset after this command is issued.

5.26

-delchap

(Delete a CHAP Entry)

Type the following command to delete a CHAP entry:

-delchap <HBA No.> <CHAP>

The HBA will be reset after this command is issued.

5.27

-pinfo

(HBA Port Information)

Type the following command to display the port information for the specified HBA:

-pinfo <HBA No.>

5.28

-isns

(iSNS Settings)

Type the following command to configure the iSNS settings:

-isns <HBA No.> [iSNS IP Address]

When the [iSNS IP Address] parameter is not specified, the iSNS client on the

specified HBA port is disabled.

The HBA will be reset after this command is issued.

5.29

-gcr

(Get Crash Record)

Type the following command to obtain crash record information for the specified

HBA port:

-gcr <HBA No.> <Crash Output File>

5.30

-rdf

(Restore Default Firmware Settings)

Type the following command to restore the specified HBA port’s firmware values to

the factory defaults:

-rdf <HBA No.>

The HBA will be reset after this command is issued.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 79 80

Pas de commentaire

Qlogic SANsurfer iSCSI HBA CLI Guide de l'utilisateur Page 66