Qlogic SANsurfer iSCSI HBA CLI Guide de l'utilisateur télécharger pdf (Page 70)

5 – Non-interactive Mode Commands

-bootcode (Update Bootcode Code Image)

5-14 SN0054621-00 B

Where:

DCHP mode (3) is valid only when DHCP is enabled.

5.39

-bootcode

(Update Bootcode Code Image)

Type the following command to update the bootcode code image:

-bootcode <HBA No.> <Bootcode Code Image File Name>

5.40

-sbootcodecid

(Set Alternative Client ID)

Type the following command to set the alternative client ID:

-sbootcodecid <HBA No.> <Alternative Client ID>

5.41

-pbootcode

(Set Primary Boot Target Information)

Type the following command to set the primary bootcode boot target and LUN:

-pbootcode <HBA No.> <Boot Target> <Boot LUN>

5.42

-sbootcode

(Set Secondary Boot Target Information)

Type the following command to set the secondary boot target and LUN:

-sbootcode <HBA No.> <Boot Target> <Boot LUN>

5.43

-cpbootcode

(Clear Primary Target Information)

Type the following command to clear the primary boot target and LUN:

-cpbootcode <HBA No.>

= Disables bootcode mode

= Manual mode

= DHCP mode

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 79 80

Pas de commentaire

Qlogic SANsurfer iSCSI HBA CLI Guide de l'utilisateur Page 70